|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
06-18-2012, 02:56 PM
|
||||
|
||||
Top end refresh
Putting in a new set of rings into my 06-300. Should I run a hone
Thru the bore or not ? Dave 
|
|
#2
06-18-2012, 05:40 PM
|
||||
|
||||
|
When I did my top end on my gasgas I ran a hone but it had very little cross hash marks on it. When I did my 450X the hash marks were good so i just cleaned it with scotch bright pad and brake parts cleaner to get the glaze off.Maybe someone with more incite will chime in.
__________________
 02 EC 200 03 MC 250 88 VT 800 01 TXT 280
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bolt kits ? & refresh ideas? | Fred1956 | General Discussions & Announcements | 5 | 01-15-2011 11:34 AM |
Linear Mode
