|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Crank seals
Hi guys does anyone have any specs for the crank seals on an 04 ec300. Bit hard to get gasser parts local(unless someone in Brisbane can tell me where to go) there is a great bearing shop very close and was thinking I?d be able to get them there if I can find specs or even better the numbers off the seal themselves. Also am I able to remove and replace both seal without splitting cases? What tool would I need to remove actual seal, never done seal replacement whilst motor still in bike?
Thx |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
gasgas 450 ecf 2013 fork seals and dust seals | alrighty | Enduro Suspension | 1 | 12-21-2016 02:46 PM |
Crank seals | Toshy | Enduro Engine - 2 stroke | 5 | 09-27-2016 01:05 AM |
Bad idle after new crank seals | adriano.ro | Enduro Intake/Carburetion - 2 stroke | 3 | 03-15-2016 11:05 PM |
Help please! (Crank seals) | spooly | Enduro Engine - 2 stroke | 13 | 10-01-2015 07:02 PM |
Big End Rebuild - crank seals | swazi_matt | Enduro Engine - 2 stroke | 9 | 09-18-2015 12:30 AM |