|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Where to buy carb seat for needle/main???
I'm on the hunt for a seat for my 2012 EC300 Race carb. It's the air striker 2 carb. I have all kinds of needles. Just need the seat that the main jet threads into and where the needle goes up and down. Any of u guys have a part number? Or a parts source for this? Thanx
|
#2
|
||||
|
||||
__________________
15 GASGAS EC 250 19 Sherco SE 125R |
#3
|
|||
|
|||
Quote:
|
#4
|
||||
|
||||
I think the part your asking for is the needle jet, which is pressed into carb body. Not a easy fix. Sudco or jetsrus would be your best chance.
Why would you need to change?
__________________
15 GASGAS EC 250 19 Sherco SE 125R |
#5
|
|||
|
|||
Because that seat wears out and allows too much fuel to pass. It can make jetting out of the ordinary. Most carbs I've had before on other bikes had removable seats.
|
#6
|
|||
|
|||
Mikuni carbs are real easy in this regard. I would have this fix professionally done on these AirStrykers though.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Main bearings kit | swehollow | Enduro Engine - 2 stroke | 5 | 01-26-2016 09:58 AM |
Keihin PWK needle jet size? (not the needle it self) | David v | Enduro Intake/Carburetion - 2 stroke | 3 | 12-05-2014 08:16 AM |
JD blue needle jetting advice AS1 carb | nknudsen | Enduro Intake/Carburetion - 2 stroke | 1 | 03-12-2014 11:28 AM |
Off main jet Is this right ? | Packman | Enduro Intake/Carburetion - 2 stroke | 4 | 03-19-2013 09:15 AM |
needle or main jet | skid jackson | Enduro Intake/Carburetion - 2 stroke | 3 | 10-30-2009 10:22 PM |