2011 ec250es signals

[arminhammer]

Anyone get signals to work on this model? Can't find flasher.


Flasher is in switch gear. If your signals don't work it's more than likely the little tin contact inside the switch is out of place.

[Moto7man]

I have a 2011 EC 300 electric start. I just installed the turn signals. Straight plug and play w/o any problems.

[Dmacjr]

What signals and switch did you use? got a new 2012 ec200 and I'll be blue plating it tomorrow. now just need the stuff to make it actually legal

[Moto7man]

My bike is an estart, it had the turn signal switch built into the estart button(if you need to buy this, order it from motocrosscenter.com, it is a whole lot cheaper.) I used the factory OEM turn signals in the front and the oem rear fender assembly came with the rear turn signals, brake light and tag light all wired up. I just had to unroll my wire harness inside the airbox and run it under the seat to the rear fender. All the plugs matched up.

[Dmacjr]

My bike came without e start. It has headlight and tail light only but I can see the harness is there for signals and speedometer. I need to get a speedometer and signals but I can't find the gg oem ones. I'm in Canada which somewhat limits where I can buy from

[Moto7man]

I'm using a trailtech voyager. It has a speedo, engine temp, GPS etc. Motocrosscenter.com sells OEM GasGas parts cheaper than anyone else. The shipping is a little more expensive but it isn't too bad. Send them an email and they will have someone respond in English. Their customer service is excellent. You can get the OEM front signals from Go Fasters, they aren't too expensive. I didn't have a taillight so I had to get the whole rear assembly.

[Dmacjr]

Thanks for the help. I'll be putting in an order today
Don

[Moto7man]

No problem.

[john r b]

Originally Posted by Dmacjr

Thanks for the help. I'll be putting in an order today
Don

You may need this switch gg part # EE10000043012 This switch plugged into
my 2012 200xc's harness now I have hi-beam low-beam-off horn button and turn signal switch,granted it's a big switch,but it's what you are looking for.
There is all ready a connector for the trail tech computer behind the front #
plate. I would get this from motocrosscenter it's a much cheaper route.
and you'll get it much faster.

[Dmacjr]

I talked to gg importer in Canada and he's digging up the oem switch and signals for me. I'm thinking its best to start off stock.
I emailed the folks at motocross Center to see what they have for trailtech.
Did you get a speed sensor installed from the dealer?