|
|
|||||||
| Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
 |
|
|
Thread Tools | Display Modes |
|
#1
02-03-2009, 09:11 AM
|
|||
|
|||
Swingarm linkage/bearing kits
Sorry for the ignorance upfront
 ...now my question. On the GoFasters site they have Swingarm Bearing and Swingarm Linkage kits. From the fiche, it appears that I need to get (2) SA bearing kits(goes in between the dogbones) and (1) linkage kit for the rest? This is assuming I want to redo all bearings in the back-end of the bike. Thx!!
Last edited by gasIdaho; 02-03-2009 at 01:09 PM. 
|
|
#2
02-03-2009, 01:29 PM
|
|||
|
|||
|
Moose
Ask Mark for the Moose kit,it has every thing! I have an '06 ec300.and that has 5 bearings 4 for the SW with two cylinders for the SW shaft one bearings for the shock. Dogbones are bushings.Make sure to pack them by rollilin them while applying grease and make sure your O-rings are seated properly.Make sure your dogbones are greased and the bushings are not worn or sloppy while attached.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Swingarm and Linkage Bearings | blitz11 | Enduro Chassis & Body | 34 | 01-12-2015 03:41 PM |
| Graphic kits | NSE.ONE | Enduro Chassis & Body | 4 | 11-19-2009 06:03 AM |
| Moose swingarm bearing kit - not so good... | stay_upright | Enduro Suspension | 6 | 03-03-2008 03:00 AM |
Linear Mode
