|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
2010 EC 300 exhaust change problems
Hey guys,
I recently changed to a DEP full system, replacing the original system For the first ride, it felt great, more responsive and crisp Second ride it felt like the bike would bog down in 3rd when opening right up, but mostly would clear and rev out I took it out today, and it just wouldn't rev past half throttle at all. I played with the mixture screw, which didn't really improve it, so I adjusted the needle, its now on the first notch, and is running better, but nowhere near as good as before. I'm guessing it needs re-jetting, although this is where i haven't a clue where to go next. Any suggestions much appreciated. |
#2
|
||||
|
||||
The DEP pipe probably flows better than the previous pipe.
Try raising the needle. Drop the clip 1 notch. |
#3
|
|||
|
|||
I tried adjusting the needle, it was on 3, i went to 2, then 4, and then to 1, that was the only setting that would let it rev even remotely close to how it should
|
#4
|
|||
|
|||
What is your jetting? Needle, jets, AS...
|
#5
|
|||
|
|||
I'm not actually sure, assuming stock, but i need to pull it apart and have a look tomorrow
|
#6
|
||||
|
||||
How old is the plug?
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Clutch problems on 2010 ec 300 | Shooter | Enduro Engine - 2 stroke | 8 | 12-22-2014 02:44 PM |
2010 GasGas 200 exhaust? | blanc | General Discussions & Announcements | 2 | 06-30-2011 06:47 AM |
Air Filters-did they change in 2010 | husley | General Discussions & Announcements | 5 | 03-08-2011 01:44 PM |
Exhaust note change?? | moto9 | General Discussions & Announcements | 3 | 12-28-2010 11:33 AM |
? on exhaust for 2010 EC300 | john01 | General Discussions & Announcements | 29 | 11-16-2010 01:33 AM |