|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Project Bike
Hi nickrhinos ,Newbie , I have a 1990 325 air cooled Gas Gas project . I am in need of workshop /owners manuals and photos , plus contact with somebody who knows this model , cheers Nickrhinos
|
#2
|
||||
|
||||
If you are in the USA, and maybe even if you are not,
check out: http://www.gasgasmuseum.com/ and talk to Jim Snell. http://www.gasgasmuseum.com/1991-1993gasgas/index.htm If this what you have? Good luck on a parts / shop manual. If all else fails. Study up on your Spanish and try the source: http://www.gasgasmotos.com/esp/frame.htm ----------------------- You might give Mike Komer at the Tryalsshop a call too. http://www.tryalsshop.com/ He has helped me with parts for my 1990 Aprilia Climber. Cheers, Jeff So. Cal. |
#3
|
|||
|
|||
Project Bike
Hi Jeff , Thanks for your reply . I have sent an e- mail to Gas Gas Museum . The closest to my model is the green and purple ?? 125 [the bikes must have being good because the colours were not]. Have found some parts suppliers over here in the U.K. it's just the problem of getting hold of technical information that is the hurdle I need to overcome now . Once again thanks , Nickrhinos
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
My latest project finished | cladoo | General Discussions & Announcements | 23 | 01-09-2011 10:46 PM |
project Ducati | boostedte37 | All Other Bikes... | 66 | 09-18-2010 07:53 PM |
Project GAS GAS 125 | GAS GAS UNLIMITED | General Discussions & Announcements | 2 | 10-22-2008 03:58 PM |
Machining Project Part 2: Bar Mounts | SpeedyManiac | General Discussions & Announcements | 2 | 03-06-2007 07:47 PM |
Machining project part 1: New Oil plugs | SpeedyManiac | General Discussions & Announcements | 9 | 02-06-2007 07:35 AM |