|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
It could be the crank sensor.
This trigers a pulse to the ECU to give spark and trigers the injector. Sometimes when they get hot they can do this. Some days they can be ok for 100miles and other times they just play up. What type of off switch do you have is it a key or just the kill button? some times the kill button can play up. When it stops working check the spark and see if it has a constant spark, if not I would replace the Crank sensor. |
#2
|
|||
|
|||
Quote:
It was a bit hot today and it was after a lengthy ridge climb. I will put it on the list for the dealer. It is just a pain because it is intermittent. Cheers again.
__________________
2007 FSR450 |
#3
|
|||
|
|||
Check the wiring for the crank sensor, They sometimes have a problem if the wiring is twisted and too close to header exhaust.
__________________
"It's Nature that Brings out the Madness" GasGas FSR450 07' |
#4
|
||||
|
||||
I have no FSE/FSR experience, but a lot with a Cannondale. If there is a mechanical relay that powers the ECU, I would look there. Vibration would break the contacts and cause the ECU power to drop out on the 'Dales. Varied with terrain and engine speed (vibration). If you continue to have problems after looking at everything else, try to vibration isolate the relay somehow. I ended up rewiring a lot of the Cannondale system and installed solid state relays, but its a major job.
|
#5
|
||||
|
||||
Relay In Air Box
Have You Replaced Relay In Air Box? I Had Same Problem (or Similar Prob.) It Was The Relay In The Air Box. Went To Napa And Picked Up Part #ar614 And It Worked Perfect. Napa One Was Sealed Unit And The Stk One Was Not. Causing Dirt To Get In The Contact. Easy Fix, If That Is Your Problem
|
#6
|
||||
|
||||
relay switch
Ronald is on the right track I think....when I was in Spain I was told by the head engineer that the 06-07 relay switch that is located under the seat behind the airbox loses its contact.
The fix was to remove cap from relay, clean contact thoroughly and when replacing cap seal it with silicone. Or replace the whole switch works eassier. The 08 will have a sealed relay switch.
__________________
Mark Berg |
#7
|
||||
|
||||
It was the same with the 05's. Go get the new one from Napa.
__________________
Dont follow me, You wont make it. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC 300 problem!!!!!!!! | clerky clerk | Enduro Engine - 2 stroke | 31 | 07-06-2011 05:19 PM |
fuel injector removal from throttle body 450s | ggg | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 06-20-2010 10:11 AM |
And then this became a problem. | dank | Enduro Engine - 2 stroke | 9 | 03-22-2010 07:58 AM |
450 injector crossover? | bergerhag | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 03-23-2008 06:44 PM |
I think I have a problem | SpeedyManiac | General Discussions & Announcements | 7 | 11-30-2007 11:26 PM |