|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Carburetor
A plastic piece that attached my carb to the air boot broke and i have not been able to find it. It also looks like i have a short body (~75mm from mouth to mouth) airstrike and the plastic piece made it possible for the air boot to reach the carb.
In the picture i am pointing to the part i am talking about also the airboot should be around the smaller end. The part looks like it is made of pp and has a grove to lock into the lip of my carb. Any information on what it is where i can get it and what carb i have is useful. Thanks |
#2
|
||||
|
||||
Try Hall's first. good luck. I've heard of the piece before but never seen one. Is the carb a 36mm?
__________________
'12 XC 200 TTX Sold '15 XC 250E Sale pending |
#3
|
||||
|
||||
if the number on top is the size than 38mm. as well the inside diameter of the outflow mouth is 38mm
|
#4
|
|||
|
|||
I removed my read block spacer a while ago and had a big gap I mounted the card to the boot and warmed the boot with a hair dryer. When it was hot enough I used a tyre lever and pushed it on to the front and clamped it up.
It stretched in to place but if it's of the bike for a while it sometimes need the dryer on it Hope this helps if you can't replace the plastic bit never had any issues with it or by doing this
__________________
03 ec300 honda cr500 94 |
#5
|
||||
|
||||
Im going to talk to my dad about calling hall's first i rather find the piece then stretch the rubber, but it is good to hear that it is a working solution.
|
#6
|
||||
|
||||
Apparently hall cycles has no idea what it is.
|
#7
|
|||
|
|||
never seen one before to be honest.
__________________
03 ec300 honda cr500 94 |
#8
|
||||
|
||||
Yeah, i don't blame you my dad called the gas gas importer yesterday and they are yet to get back to us.
|
#9
|
||||
|
||||
Halls, gas gas importer, epic and JD have not heard of this part.
Edit: Epic found it Last edited by liamthom; 03-19-2015 at 01:56 PM. |
#10
|
|||
|
|||
I have one of those on my 2011 gasgas ec200 38mm AS1 carb. I have 3 or 4 other gasgas carbs and none of them have this spacer.
Try to find a part number on yours. Or you may have to measure it. Then check this page: http://www.jetsrus.com/mounting_flan...tml#offiintake After looking some more the above link may just be rubber manifolds. I think you should just do the hair dryer trick and eliminate the spacer
__________________
2011 GasGas ec300R 2011 GasGas ec200 Six Days |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lectron Carburetor Testing & Adjustment | singletracker | Pictures & Videos | 4 | 01-12-2013 09:37 AM |
balanced carburetor | 300ec | Enduro Intake/Carburetion - 2 stroke | 12 | 02-21-2012 10:07 AM |