|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
map switch, in or out?
Guys a newbie question, I have just bought an 07 ec300, it has switchable maps, I haven't had a chance to ride it yet, just wondered whether full power was in or out on the switch?
Ta |
#2
|
|||
|
|||
hi,there should be a sun and a cloud on the switch,sun is dry/full power,cloud is a little milder power,if there worn off,down(big swich in)is sun/full,up(little swich in)is milder setting.
__________________
2009 ec300 2011 plastics |
#3
|
|||
|
|||
Thanks, does it make a big difference?
|
#4
|
|||
|
|||
seems to be quite a lot less agressive in the wet mode,but if you have the 2k2 ignition the difference is not as noticable.i use the wet mode most trail rides out.but on the mx track is full on
__________________
2009 ec300 2011 plastics |
#5
|
||||
|
||||
I run on the wet setting at all times unless on the motocross track, which may be a 10 minute run a year... I have a 300 with the big ignition, and it seems to make a fair amount of difference. Otherwise it really seems to be a somewhat traction control type of thing it just hooks up so nicely on that setting (Wet/Cloudy).
$.02
__________________
2013 GasGas 300 2004 GasGas 200 2011 GasGas 300 Ortonville Minnesota |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Switch | Rabbitist | General Discussions & Announcements | 1 | 05-24-2011 07:10 PM |
CDI switch on an EC200 | captainslow | Enduro Engine - 2 stroke | 1 | 10-26-2010 12:50 PM |
missing CDI switch | captainslow | Enduro Electrical & Wiring | 0 | 05-20-2010 08:38 AM |
Dual Map switch.. | stevehipkiss | Enduro Electrical & Wiring | 3 | 01-28-2010 01:29 PM |
headlight switch | jasont1532 | Enduro Electrical & Wiring | 1 | 03-02-2009 07:20 PM |