|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#51
|
|||
|
|||
Quote:
__________________
Dick Carnes "If ya run, you'll only die tired" 2019 EC 300 2018 GP 300 2013 XC 300 (sold) 2006 DE 300 (buddy has it) |
#52
|
||||
|
||||
Yeah its a little harsh. I have a pair of 5009s on the way, and got my welded kicker shaft back. The issue again, will be acquiring a ring gear.
The kicker shaft looks good. Tacked, notched, and welded. The welder seemed confident it will last. He said since I broke 2 shafts in the same way and it is all fresh break that there was likely some impurities in the steel.
__________________
2021 Beta 300RR 2014 Gasgas XC300R 2019 850 Pro RMK |
#53
|
||||
|
||||
I took a close look at the failing bendix to see what was up. The tin cup has come loose from the back of the 40t gear, it can't spin free but it wobbles. Otherwise it seems fine. When I get time I'll disassemble it, and see if there's anything I can do with it.
__________________
2021 Beta 300RR 2014 Gasgas XC300R 2019 850 Pro RMK |
#54
|
|||
|
|||
I bought a 2014 ec300ER a week ago, brand new. Starter failed within three days. Kickstarter is made of butter so that's scrapmetal now also.
I replaced my bendix, which was completely stuck, with another one available everywhere: 82612R What you have to do to make it fit is remove the clip (ring) from the shaft to remove everything but the upper gear, cup and shaft. The upper gear on this bendix is thicker and thus the shaft is longer, you cannot use that. Put everything you removed on the original bendix shaft en put the original clip/ring back in the groove. Make sure the clip is all the way in the groove so the bottom cup fits on the ring also. it has a small groove that fits around the clip. that way you ensure that it is low enough so the bottom sprocket wil grip the flywheel sprocket. I put the two original small washers in at the bottom and the top of the shaft. This is a winner, start every time! no sounds of teeth kicking in, just normal starter sounds. And as long as i press the button it keeps turning the engine. |
#55
|
|||
|
|||
Quote:
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Just a hillclimb FAIL - Lesson 1 How to break rear fender | blamir | Pictures & Videos | 3 | 04-06-2015 11:34 AM |
First real fail........ | houndog | Injury & Recovery | 27 | 06-16-2013 12:36 AM |
Wiring Epic Fail (2011 EC200 Six Days) | TEricksen | Enduro Electrical & Wiring | 0 | 02-02-2012 08:24 PM |
wet clay + shot rear tyre = fail | boundy | Pictures & Videos | 21 | 03-31-2010 03:32 PM |