|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
clutch rivet size help and will it fit my 013
a while back i brought a clutch basket with gear of a gg 250 it has a date stamp of 08 on the basket all the rivets have bean drilled out any one no the size of the rivet , the hole size is 4.2 can i use 1/8 mild steel rivet .also will it fit my 013 300 thanks
|
#2
|
||||
|
||||
I believe standard pop rivets will not work. I would tap the holes and use screws with Loctite like everyone does for aftermarket baskets.
|
#3
|
|||
|
|||
sorry forgot to say its a gg std basket
|
#4
|
||||
|
||||
I think it is still common for people to tap threads into the stock basket and use bolts to put it back together.
|
#5
|
|||
|
|||
I used "Reaper Rivets" from a farm shop on a husky I was restoring. I think they are used for holding flail blades onto something, close to 5mm Dia, 20mm long and just cut them down to right length.
I struggled to find the right Dia/length/CSK combination anywhere. Rivets are mainly an aviation thing these days 100/130? csk angle. 5/32 would be a better fit for 4.2mm hole, ideally you would want a 4mm metric rivet. Remember to get a rivet long enough to allow proper forming of the head, typically stack thickness +1.5x dia. There should enough material to open up the hole a little to allow for a bigger rivet or re-cut the csk to suit something you can get. EDIT#Never been inside the gasgas clutch so not sure how the rivets are.... |
#6
|
|||
|
|||
iv found 1/8 cks rivets on uk ebay only 3.00 uk for 10
|
#7
|
||||
|
||||
We're the rivets Aluminum or stainless steel? Please let us know how it works out.
|
#8
|
|||
|
|||
The rivets I drilled out of the husky were steel.
I replaced them with a steel rivet. I used something like this http://www.sapphireproducts.co.uk/641t9.htm |
#9
|
|||
|
|||
I just had this issue I drilled out my only to find the new one was not correct. I did want to wait for a new one. I used stainless rivets and had to peen them for clearance. No problems
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Clutch fiber and steel size??? 2011 GG EC 300 | jb250xcf | Enduro Engine - 2 stroke | 2 | 11-05-2016 05:16 AM |
Magura clutch MC size on 2012 XC300? | Bandit9 | Enduro Chassis & Body | 2 | 11-05-2013 07:01 AM |
Clutch lever doesnt release clutch as soon as motor starts | cal_tony | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 05-19-2012 08:59 AM |
Masterlink...Rivet or Clip | Rick | Enduro Chassis & Body | 9 | 11-27-2009 07:17 PM |