|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#2
10-31-2014, 03:25 PM
|
|||
|
|||
I'm on my phone right now so can't tell directly. But I found it by looking at the parts list on gas gas website, then Google the part number, I think it was 23x2 but can't be certain.
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crank Remover and Crank Installer tools for EC250 | Fabry | Enduro Engine - 2 stroke | 5 | 06-25-2013 07:24 PM |
| Exhaust o-ring size anyone know off hand? | nambo-trev | Enduro Engine - 2 stroke | 3 | 09-07-2012 10:44 PM |
| ohlins ttx lock ring cap screw size.any one know? | nambo-trev | Enduro Suspension | 0 | 05-03-2012 10:10 PM |
| ec300 Exhaust O ring Size | Bradz | Enduro Engine - 2 stroke | 12 | 11-09-2010 12:03 PM |
| crank seal size | rupecopp | Enduro Engine - 2 stroke | 3 | 04-18-2008 09:11 PM |
Linear Mode
