|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
right side crank nut
Hey all, stupid question is the crank nut right hand thread or left.. nut is very tight and I am starting question myself on witch way to loosen. I have rebuilt lots of jap bikes and never had the crank nut so tight before.
|
#2
|
||||
|
||||
Its reverse thread. Use something soft to lock the gears, get some heat into it to loosen the thread lock, and then hit it with a decent breaker bar. Right to undo.
Other option is to get some heat and hit it with an impact wrench. Should undo in a few braps. |
#3
|
|||
|
|||
Thank you
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ignition side crank bearing failure? | wence | Enduro Engine - 2 stroke | 37 | 06-16-2016 07:21 PM |
Crank Remover and Crank Installer tools for EC250 | Fabry | Enduro Engine - 2 stroke | 5 | 06-25-2013 07:24 PM |
gas gas ec 200 crank | chinesegav | United Kingdom | 5 | 11-27-2012 06:49 PM |
Crank it up! | Rick | Pictures & Videos | 2 | 04-09-2011 12:36 PM |
Right side crank seal question | noobi | Enduro Engine - 2 stroke | 5 | 07-16-2010 07:49 PM |