|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#51
|
|||
|
|||
I bet he finds that it runs like a scalded kangaroo now!
Note: Always pay attention to Jakobi.
__________________
2011 EC250E |
#52
|
||||
|
||||
I hope so! (that she screams like she should).
air in, exhaust out, fuel, compression and ignition! had to be one of them! |
#53
|
|||
|
|||
Quote:
But, you can have 50%, and Neil gets 50% for his electrical knowledge
__________________
07` EC300SM. 09` KTM 250EXC. 70`CB350 |
#54
|
||||
|
||||
Quote:
Anyway, I've crossed my fingers and am holding my tongue to the side just the right way hoping you've finally got her running right. |
#55
|
|||
|
|||
Quote:
EDIT: Thank you everyone! Problem is now cured! Revs out nice and even! Its not a singer like my old RS250, but either way, its reeving freely! Thanks!
__________________
07` EC300SM. 09` KTM 250EXC. 70`CB350 Last edited by stian; 06-03-2016 at 04:11 PM. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GasGas Workers Reach Agreement | Moto7man | General Discussions & Announcements | 22 | 05-11-2015 05:50 PM |
Gas gas ec300 not hitting powerband | candybuddy | Enduro Engine - 2 stroke | 10 | 08-13-2014 12:33 PM |
How high do you go to reach some snow. | HuskyDude | Ride Reports | 2 | 09-06-2011 09:24 PM |
gasgas ec300 05 model wont hit full powerband??!?!?!? | jimmyT | Enduro Engine - 2 stroke | 9 | 08-30-2011 11:31 PM |
Cyrca Center Reach Mount | Brian | Enduro Chassis & Body | 1 | 11-03-2009 06:17 AM |