|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Power valve oil tube
Hello i have a 2002 ec300 and im running putoline mx9 at 50-1 but my power valve is dripping oil out the tube is this to much oil or is this a good mix for the mx9?
|
#2
|
||||
|
||||
They will sponge more if you are jetted rich, but if they are not ridden hard they will sponge even when jetted correctly especially with high flash point oils.
|
#3
|
||||
|
||||
I've Always run 40:1 so 50 is not too much. Jetting will reduce spooge and it's the needle that will make your change. But who cares if there's s bit of drip? It's what it's for. Actually I cable tie mine up and drain it ever so often.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Power Valve vent tube | shang | Enduro Engine - 2 stroke | 8 | 07-23-2015 07:32 PM |
Loss of power - suspect power valve | Jonny Halls | Enduro Engine - 2 stroke | 4 | 01-22-2013 09:56 AM |
power valve nut | bonkeye | Enduro Engine - 2 stroke | 4 | 10-11-2012 06:40 PM |
Power Valve Vent Tube?? | EtienneNZ | General Discussions & Announcements | 16 | 09-19-2010 09:53 AM |
Power valve | bens25au | Enduro Engine - 2 stroke | 2 | 02-09-2008 11:02 PM |