|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Hand Guards
What would be a good pair of hand guards to put on my 05 GasGas EC250 for riding enduros?
|
#2
|
||||
|
||||
Cycra Pro Bends.
|
#3
|
||||
|
||||
with the BONZ mounts...Gets the clamps off the bars for a really clean setup and you can buy the Cycra's without the bar mounts for less money. The new Enduro Engineering Evolution guards you can also get without the bar mounts if you like those.
http://www.bikebonz.com/images/siteb...hgm/sm_hgm.htm Skidad in MA |
#4
|
||||
|
||||
FYI, I really like the Bonz mounts but I have read cases of them bending in a crash. In an attrmpt to avoid this, I mounted my guards with BRASS M8 bolts. I had a very hard crash, worse than average, and the bolt bent slightly with no damage to the guard or mount. I keep a couple extra botls in my fanny pack if needed on the trail.
|
#5
|
||||
|
||||
Quote:
Thanks, Skidad in MA |
#6
|
|||
|
|||
they work on the gassers just fine even tho they say it's for ktm??
|
#7
|
||||
|
||||
They are on my Protect with 40mm hole centers same as OEM GG bar mounts, so they should fit fine.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Left hand rear brake??? | getndirty | Enduro Chassis & Body | 71 | 12-29-2014 02:56 PM |
Hand Tape Survey | SpeedyManiac | Enduro Product Announcements | 4 | 04-22-2010 05:09 AM |
Hand guard issues | jhendr3702 | General Discussions & Announcements | 3 | 09-03-2008 04:10 PM |
Sand under left hand PV cover!!! | highspeedsteel | Enduro Engine - 2 stroke | 11 | 08-22-2007 02:36 PM |
Hand Numbing? | Boomhauer | General Discussions & Announcements | 17 | 02-23-2007 09:37 AM |