|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do I remove stator cover? (4-stroke)
2007 FSR450
I need to replaced pulsar sensor coil, which I already have in possession. How do I get the damn stator cover (left) off? I removed starter, removed small cover bolts and then removed the big nut holding it on. Do I need a flywheel puller? Because I also tried ordering a 27 and a 28 mm external thread flywheel puller and no dice, neither of them fit. The 27 mm was too small and the 28 mm was the internal threaded one. I can't find a 29 mm external thread. Some guidance is much appreciated. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stator cover | adv rider | Enduro Engine - 2 stroke | 1 | 04-30-2014 10:19 AM |
Remove valve cover - Impossible [450 SFE -05] | luzt | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 02-18-2013 06:52 AM |
Gear lever - cant change up, rubbing on stator coil cover | KTMAndy | Enduro Chassis & Body | 7 | 04-05-2012 09:38 AM |
how do you remove the kickstart | noobi | Enduro Chassis & Body | 13 | 09-22-2011 03:31 PM |