|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Used a little heat. I've never seen a kickstarter get so stuck before.
How do you delete a thread ? Last edited by biggstr6; 05-31-2014 at 06:18 PM. |
#2
|
||||
|
||||
Try a small puller but put a nut or washer on the shaft to protect the threads.
|
#3
|
|||
|
|||
Look at the little box at the bottom left of the topic page. It's called posting rules. It doesn't say "you may delete your own threads", so this function has been reserved for moderators. The most you can do is edit the post to remove content.
All forum software has permissions set up by the board administrator. The admin decides which ones the users will have.
__________________
2011 EC250E |
#4
|
||||
|
||||
Quote:
Quote:
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Removing wiring | Bandit9 | Enduro Electrical & Wiring | 1 | 10-15-2013 09:24 AM |
Removing carb | Binni | Enduro Intake/Carburetion - 2 stroke | 5 | 02-25-2011 09:24 AM |
Removing Rear Shock | gasIdaho | Enduro Suspension | 12 | 02-04-2009 10:45 AM |
Removing shock | thelonius | General Discussions & Announcements | 3 | 08-30-2007 08:50 PM |
Removing the fork cap? | sanderjavant | Enduro Suspension | 4 | 07-22-2007 11:35 AM |