|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Yes, good point!
I was hoping that someone out there has already tried this with the 9.5mm bore. Getting information has been difficult, but it is good to know that someone has tried this with the 10.5mm bore and it works. Has anyone used a magura clutch master cylinder off of a 4Stroke? Zeal |
#12
|
||||
|
||||
Zeal,
I've used a 9.5mm (newer KTM 2T) master cylinder on my 06 EC 300 and I'm currently using a 9.0mm (KTM 4T)master cylinder on my 08 EC 300. The 9.0 has a slightly lighter pull than the 9.5, but is more expensive because it comes with the manual decompressor cap and lever. Both bolted right up with no modifications. Jason |
#13
|
|||
|
|||
Jason,
Great feedback! I will try to find a 9.0mm bore and hook bolt it in. Zeal |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ASV levers for AJP master cylinder? | colinmc400 | Enduro Chassis & Body | 4 | 06-04-2008 05:56 PM |
Looking for a clutch master cylinder assembly... | SpeedyManiac | General Discussions & Announcements | 5 | 05-09-2008 07:06 PM |