|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
What are your ideas of the must have upgrades to a standard 300ec
I have just picked up a 2010 300 and was wondering where i should go with putting addons to it so all you experienced 300 owners i would love to hear your thoughts, Thanks in advance Nato.
|
#2
|
||||
|
||||
Skid plate, radiator bracers, bark busters and you're good to go
|
#3
|
||||
|
||||
Agree with bergerhag.Put in a JD jetting kit if you want to clean it up & see the full potential of the engine,& just ride it.
|
#4
|
||||
|
||||
Suspension. Front fork revalve a must!
|
#5
|
|||
|
|||
By radiator braces do you mean guards or actual braces?
|
#6
|
||||
|
||||
Did you have your forks revalved? I've been running stockers so far. Bit firm and could use a few mms less oil in them but otherwise very predictable and compliant.
As everyone has said, these bikes don't need much at all. Set suspension for your weight (sag etc.) Rad braces/guards/Bash plate/Pipe Guard Rejet for elevation and conditions (especially if stock) Then down the track consider head work with first top end and suspension revalve once broken in and evaluated. |
#7
|
|||
|
|||
I would also say the RB mods are a must.
|
#8
|
||||
|
||||
|
#9
|
|||
|
|||
On my 2010 ec300,
I have rejetted numerous times, landing at what I call near perfect. I also have let out 20cc of oil from each fork leg. It took the forks nearly 20 hours of riding, half of it moto, for them to break in. The shock felt great to me out of the box. I installed a set of YZ450 titanium footpegs. This is the first bike I have had where I didn't rip the suspension apart or send it off.
__________________
'10 EC300 -- very happy Last edited by Bailey28; 09-06-2011 at 07:10 PM. |
#10
|
|||
|
|||
Send the head and carb to RB Designs, send the forks to House of Horsepower or LTR put on a skid plate and let'r rip. I think the shocks are pretty good as they come. Radiator guards are nice, i dont use a pipe guard they cost as much as a new pipe. Hand guards are a must, I like Enduro Engineering.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
03 450fse advice on upgrades to improve starting | hillbilly | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 06-23-2011 07:42 PM |
Brake upgrades? Oversize kits? | pj7 | Enduro Chassis & Body | 15 | 04-16-2011 01:23 PM |
Website Back up after upgrades... | webmaster | General Discussions & Announcements | 12 | 11-01-2010 05:55 PM |
looking for ideas?? | tub350 | Enduro Intake/Carburetion - 2 stroke | 4 | 08-18-2007 03:09 PM |
Board upgrades today/tonight. | webmaster | General Discussions & Announcements | 0 | 11-12-2006 01:04 PM |