|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Gearlever Problem
The gearlever on my bike is hitting the ignition cover, if i move it on the splines it then hits the frame.
I have 2 levers an OEM one and 1 aftermarket they both do it and its driving me nuts, having to pull the lever by hand. the lever shaft is not bent as i replaced it as i bent the original one. should i buy a shorty trials one? |
#2
|
|||
|
|||
Heat it up and bend it a tiny bit
|
#3
|
||||
|
||||
fixed it, found the camping stove heated it up and smacked it with the hammer.
worked a treat, the persuader always is the tool that gets shit done |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Have a GG but I might have a problem | drdfblackm | General Discussions & Announcements | 20 | 12-17-2013 06:42 PM |
wanted !! gearlever shaft | savage sausage | Parts | 4 | 06-26-2013 12:30 PM |
I bought a 2000 xc and keep finding problem after problem | 675AZ | Enduro Engine - 2 stroke | 12 | 02-15-2013 07:25 PM |
And then this became a problem. | dank | Enduro Engine - 2 stroke | 9 | 03-22-2010 07:58 AM |
I think I have a problem | SpeedyManiac | General Discussions & Announcements | 7 | 11-30-2007 11:26 PM |