#11
|
|||
|
|||
Began stripping it down, came to getting the barrel off and of course I had to de-link the power valve but couldn't figure out how??
From what I could see I had to remove "A" to get the arm off but it was just spinning? I could feel behind the nut and it was spinning too, how am I meant to release it? I checked on the other side of the engine and nothing was moving too! |
#12
|
|||
|
|||
Quote:
Get a new one on the way (or weld it). Back out "C" and undo the nuts holding on the cylinder. Lift the cylinder a bit and then you might be able to finagle the thing out of there. The other option is to drill into the stud and use an EZ Out as backup while you loosen the nyloc nut. |
#13
|
|||
|
|||
I definitely won't be able to get that part through the barrel for sure. My only option would be getting the bottom end of the arm off the bottom mechanism and sliding it up with the barrel, will that work do you think?
Is it a common problem for the weld to break? Would it affect the bikes power? |
#14
|
|||
|
|||
I don't know what I was thinking. You'll have to get that nyloc off no matter what. Not sure about pulling the arm up out of the case.
It won't affect power until that stud falls off. |
#15
|
|||
|
|||
Heat the nut to melt the nylon insert part (takes less force to turn after melted out). Use a thin cutting disc on a dremel to slot the shaft. Hold the shaft with a screwdriver and then unscrew the nut.
__________________
2011 EC250E |
#16
|
|||
|
|||
Which shaft? The nut is moving the bolt it is screwed onto and not moving anything else. I really can't think of a way to get it off.
|
#17
|
|||
|
|||
Get a set of reverse drill bits and drill into the stud. Use a wrench as backup. Best case scenario, the drill bit turns the stud and your nut backs off. Second best case is you use an EZ out in your newly drilled stud to back the nut off.
Last edited by GGRider01; 05-20-2016 at 06:07 PM. |
#18
|
|||
|
|||
So I get something into the stud and then with something into the stud I move the nut and hope it comes off is what you are saying?
|
#19
|
|||
|
|||
Yeah. Neil's method sounds pretty easy too, and you're more likely to have a dremel than reverse drill bits. However, EZ outs don't care if the hole was drilled in reverse or not
|
#20
|
|||
|
|||
That seems like my only option but before I jump into that in the pic below do you know if I can remove the thing circled in red? I think if I can disconnect that somehow I can pull the barrel off and the arm will come up with it.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
More ec 200 problems | gump147 | Enduro Engine - 2 stroke | 9 | 06-01-2015 03:15 PM |
Wanted!! Ec200 seat, radiators, switch gear, gear lever | Kendog | "Wanted to Buy" & "Want To Trade" | 2 | 10-12-2014 03:12 PM |
yet more problems | bonkeye | Enduro Electrical & Wiring | 9 | 08-17-2013 09:48 AM |
Gear problems... | jonnyweston | Enduro Engine - 2 stroke | 3 | 01-04-2008 05:55 AM |
06' ec 200 problems | speed addic | Enduro Engine - 2 stroke | 0 | 02-25-2007 06:44 PM |