|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
hello there
I´m a new one here I have a 08 GG EC300 racing ölhins front and rear ,does any one have some good advise for me too setup the suspencion for me I´m 110 kg gear on glub rider scale ride mostly in hard terrain 1,,2,3 gear enduro
|
#22
|
|||
|
|||
I was reading your posts regarding the bottom fork clamps being even 1mm out will cause stiction. I have two 2003 EC's one is a 250 one is a 300. Both are ohlins and I was swapping one set to the other because my 250 had a better set up. When I did this I found the 250 Ohlins tubes were approx 1mm larger and I had to spread the bottom clamp to fit them to my 300. The ohlins from the 300 slid right onto my 250 with no problems. My 300 is an early 300 model and my 250 is a late 2003 model. Any thoughts?
|
#23
|
||||
|
||||
One is a 36mm, the other 38mm.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Triple clamp offset??? | Keg | Enduro Suspension | 3 | 10-08-2009 07:48 PM |
Top triple clamp | pharrell | Enduro Chassis & Body | 10 | 01-16-2009 12:57 AM |
BRP top triple clamp | Link | General Discussions & Announcements | 1 | 11-08-2007 08:28 AM |
Triple clamp torques ? | Brian VT | Enduro Suspension | 3 | 01-27-2007 06:54 AM |