|
|
|||||||
| General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-29-2009, 12:48 AM
|
|||
|
|||
Snapped bars
8klm into a ride today and I hit a rock that threw the front wheel out from under me. End result bars snapped and a sore body. They are standard from new, anyone seen this before? Any suggestions for direct replacement would be greatly appreciated.
Thanks in Advance Adam Edit: rider error caused breakage  http://www.vimeo.com/3902513
__________________
Adam 2006 FSE450...Gone 2011 EC300e  Sunshine Coast, Queensland Australia 
|
|
#2
03-29-2009, 06:43 AM
|
||||
|
||||
Bummer
That is rather impressive. Your group sounds a lot like mine,gona be a lot of ribbing about that
 I think I would get some pro tapers
__________________
 02 EC 200 03 MC 250 88 VT 800 01 TXT 280
|
|
#3
03-29-2009, 02:35 PM
|
||||
|
||||
|
Man those bars look very thin walled. My stock Hebo bars have very thick walls and even had to drill them to put hand guards on.
If I need to replace them I think I'll be looking in to Pro Tapers.
__________________
2004 GasGas DE250
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| offset bars | jasont1532 | Enduro Chassis & Body | 2 | 02-10-2009 06:32 AM |
| Snapped valves on 02 400 | douglase1983 | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 01-10-2009 01:33 PM |
| Bars | Dingo | Enduro Chassis & Body | 8 | 09-12-2007 09:55 PM |
| 7/8 vs 1-1/8 bars? | eff | Enduro Chassis & Body | 1 | 02-17-2007 07:30 AM |
Linear Mode
