|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2k-2 ignition puller size?
Hi all, I put a 2k-2 ignition on my 07 GasGas and remember the 2k-3 ignition came off using a puller my buddy had for his YZ (pretty much standard size for most full size bikes) however the 2k-2 puller threads were a smaller size from what I remember, actually had to grind the flange off the retaining bolt for it to fit into the flywheel. Does anyone know what size puller is used to remove a 2k-2 flywheel? Thanks for any help.
|
#2
|
||||
|
||||
I used a puller from my YZ426, worked perfectly. Should be same as the YZ250 puller.
__________________
Phil (New bike pending...) |
#3
|
||||
|
||||
Same Kokusan puller, used on every YZ and KTM. I don't understand why you would have to grind anything. The body of the puller threads into the flywheel CCW, and the bolt is tightened CW.
|
#4
|
|||
|
|||
27mm x 1.5mm as i recall, just get that confirmed as i'm not 100% sure.
|
#5
|
|||
|
|||
Hmm..I could have sworn the puller threads on the 2k-2 were smaller than the 2k-3 I took off. I'll go check it as I have'nt pulled the flywheel cover off in awhile. I have a YZ puller that I took the 2k-3 off with but I thought it was too big to pull the 2k-2 off.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flywheel puller | racepaul | Enduro Engine 4 stroke (including EFI & Exhaust) | 0 | 04-22-2010 06:19 AM |
Flywheel Puller | hudson_hollow | Enduro Product Announcements | 1 | 01-04-2009 09:00 PM |
Flywheel Puller? | PBWR450 | Enduro Engine - 2 stroke | 3 | 12-12-2008 05:43 PM |
FLywheel puller. | Ud_luz | Enduro Engine - 2 stroke | 1 | 04-25-2008 12:53 PM |
04 300EC Ignition changed to DE Ignition | Trail Blazer | Enduro Engine - 2 stroke | 0 | 01-08-2007 01:48 AM |