|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Clutch Slave. How much movement?
I'm new to hydraulic clutches so would really appreciate some info.On an EC250 1999 how far should the clutch slave piston move on full lever travel? On mine it seems to be about 2mm, doesn't seem much?
I'm trying to rules out some possible causes to a problem I have with disengaging the clutch. |
#2
|
||||
|
||||
That sounds just a little short, mine is 2.4 mm.
__________________
13 GasGas 300XC, CLake and now Rekluse 17 Beta 430 RRS, Clake 19 Vertigo 300 03 H-D Nightrain www.newoodsriders.com You Can't Out Run Death Forever But You Can Make the BASTARD Work For It! Enjoy Life, Have Fun and Play Hard |
#3
|
|||
|
|||
Thanks for that. It was only a guess on my part, I haven't measured it correctly. It sounds as if its working as it should.
FWIW the clutch will not disengage but it has sat for a while so it might just be the plates are stuck. |
#4
|
||||
|
||||
mine would do that when parked for a while..
__________________
broken down over 60 slow rider.. |
#5
|
|||
|
|||
How do you free it? I was going to start it on the stand, knock it in gear, then rev it up while operating the clutch and brake. Probably not the most intelligent approach!
|
#6
|
||||
|
||||
Quote:
probably not the best option either, but always worked..
__________________
broken down over 60 slow rider.. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
clutch slave | vwboomer | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 06-12-2012 04:04 PM |
Clutch Slave Cylinder Rebuild | newgaser | Enduro Engine - 2 stroke | 5 | 03-17-2012 08:30 AM |
Clutch Slave Cyliner - where's that spring go? | mrkartoom | Enduro Engine - 2 stroke | 4 | 04-24-2011 10:11 PM |
clutch slave movement ? | jhendr3702 | Enduro Engine - 2 stroke | 0 | 03-16-2011 03:44 PM |
Oil around Clutch Slave | rickster2 | Enduro Engine - 2 stroke | 5 | 08-29-2006 11:27 AM |