|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Clutch problem :)
With clutch plates off,I've tuch the clutch lever and now the lever is hard when is pulled. What I need to do next?
|
#2
|
|||
|
|||
You have bottomed the slave cylinder. Just put your throw out bearing in and push it in. Should be good to go. Or just reinstall the clutch and it will push the slave back in
Sent from my iPhone using Tapatalk |
#3
|
|||
|
|||
What can cause metal clutch plate breaking ? Firat metal plate on the engine side was broken. Clutch work just fine. I have some rattle, seams to be from power valve,my exhaust o-ring gone also.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC 250 clutch problem | BluegassXCR | Enduro Engine - 2 stroke | 0 | 07-22-2011 08:27 PM |
450 Clutch problem | trxpeter | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 09-03-2010 12:38 AM |
also an ongoing clutch problem...... | dank | Enduro Engine - 2 stroke | 2 | 05-19-2010 01:24 PM |
ec300 clutch problem | dirtjunky_uk | Enduro Engine - 2 stroke | 13 | 02-27-2009 08:08 AM |
450 Clutch problem | mike989 | Enduro Engine 4 stroke (including EFI & Exhaust) | 17 | 01-02-2008 08:54 AM |