|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
thanks Matt....on KTMs thats where I ran them too.....i like to be up as far as I can.....thanks
__________________
2008 EC300 Rekluse |
#12
|
||||
|
||||
I've been told by younger guys that ride my bike that I have them in the "old man" position.
|
#13
|
|||
|
|||
guesing thats the rear holes....i know on ktms the rear holes made me wanna sit down....
__________________
2008 EC300 Rekluse |
#14
|
||||
|
||||
I use the front holes, and I am only 5"6. I find this makes me stand and crouch and gives good control over the front end. Yes, the clamps bolts are off-set so in fact you have 4 position choices. As for the slippery seat.... stand up! ALL the time! The only purpose of the seat is to give you somewhere to sit your gloves while you're gassing up
__________________
Barry 07 EC250 |
#15
|
||||
|
||||
I set my 11 250 up when I got it in the front holes and ran moose hybrid pegs with 1/2 " rear offset...it felt comfy that way for me 6 ft 200lbs I have 30 hrs on the bike
One day I tried the rear holes for the bars just for the hell of it.....and OMG there was just no way.....its unbelievable how a half inch makes so much difference...so I put it back |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rear brake position | Lildawg | Enduro Chassis & Body | 18 | 06-15-2011 11:17 PM |
Changing needle position? | EcEvan03 | Enduro Intake/Carburetion - 2 stroke | 6 | 04-27-2011 03:09 PM |
Handlebar mounting position | bchatt | Enduro Chassis & Body | 8 | 10-14-2010 05:34 AM |
neddle position Question | biggstr6 | Enduro Intake/Carburetion - 2 stroke | 8 | 05-12-2010 10:26 AM |
Clip position ? | thingymijig | Enduro Intake/Carburetion - 2 stroke | 3 | 03-01-2007 04:57 AM |