|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Crank bearings
Just received stator side crank bearing.
It is double rubber protected. I guess there is no need to remove rubber, as it is self lubricated. Had bad experience using non oem, but quality branded C4 bearing on stator side. Crank had play in bearing from day 1. Cases and crank are not worn. Will use regular branded C3 on clutch side, as previous showed no deterioration. Just dont know if rubber protection should be left or not. As I remember, only one side was protected, but dont know which, towards chamber or gearbox.
__________________
EC 300 2008 EC 300 2018 GP tenere 700 |
#2
|
||||
|
||||
Pull em all out. Premix does the lube and no point shrouding it from any side. Seals are for wheels.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#3
|
||||
|
||||
Yup! I concur!
__________________
WildAzzRacing YouTube channel Trail Riders of Southern AZ club AZ State Parks OHV Ambassador '11 EC250R '98 KDX220 |
#4
|
||||
|
||||
|
#5
|
||||
|
||||
Is that the correct bearing?
I am really surprised that a manufacturer would supply a sealed bearing for use on a crank as I would expect the seal to melt and cause all kinds of problems in the combustion area. |
#6
|
|||
|
|||
Its oem gg ordered bearing.
When i removed original bearing, it had protection installed. I guess if you get accidental debris like sand inside it does offer some protection. But will remove.
__________________
EC 300 2008 EC 300 2018 GP tenere 700 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
08 Crank Bearings | PEB | Enduro Engine - 2 stroke | 17 | 12-04-2012 10:27 PM |
Crank bearings | Marki | Enduro Engine - 2 stroke | 2 | 12-29-2011 11:47 AM |
Crank Bearings? | GasGas | Enduro Engine - 2 stroke | 1 | 07-13-2008 03:24 PM |
crank bearings | steve | Enduro Engine - 2 stroke | 0 | 02-06-2008 02:51 PM |
2008 Crank Bearings | Skidad | General Discussions & Announcements | 46 | 01-03-2008 09:44 PM |