|
|
|||||||
| Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
|
Thread Tools | Display Modes |
|
#1
05-09-2009, 01:08 PM
|
||||
|
||||
fse 400 valve timing ???????
Hello everyone - new on here and this is my 1st post hopefully I can get a bit of help
Just replaced the cylinder head on my GG and couldnt mark anything up before stripping as the chain had jumped the pulley and bent valves etc etc anyway according to a thread I was looking at on thumper talk there should be a timing mark on the flywheel to indicate the correct TDC - well I aint got one of them , I cant even tell where the ignition pick up gets its signal from Any assistance here would be greatly appreciated (esp with photos) I have the 15 pins between the marks etc thats all ok I am just not sure if I have set up on exhaust TDC or ignition TDC Thanks in advence Dave 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 450 Fse Valve Train and Timing | twowheels | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 09-23-2010 06:36 AM |
| Timing a 450? | iancp5 | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 05-28-2010 10:17 AM |
| FSR 450 valve check and timing chain | ggg | Enduro Engine 4 stroke (including EFI & Exhaust) | 0 | 04-22-2010 01:40 AM |
| 07 timing? | wence | Enduro Electrical & Wiring | 15 | 10-28-2009 03:42 AM |
| Need HELP with timing | gasser | Enduro Engine - 2 stroke | 2 | 03-23-2009 02:17 AM |
Threaded Mode