|
|
|||||||
| Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
 |
|
|
Thread Tools | Display Modes |
|
#21
03-15-2012, 04:32 AM
|
||||
|
||||
I believe they mean the angle that the bars leave the clamps should run parallel with the fork tubes. Imagine drawing a line from the forks up through the center extended past the bars. The sweep will then define where the grips end up.
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stator position | Goody4 | Enduro Electrical & Wiring | 4 | 11-08-2011 05:20 AM |
| Looking forward to these new Goggles | HuskyDude | General Discussions & Announcements | 62 | 06-17-2011 11:14 AM |
| Paying it forward: Tire Stand drawing | SpeedyManiac | General Discussions & Announcements | 1 | 06-03-2009 01:30 PM |
| Clip position ? | thingymijig | Enduro Intake/Carburetion - 2 stroke | 3 | 03-01-2007 04:57 AM |
Linear Mode
