#1
|
|||
|
|||
anyone have a broke clarke breather tube?
i did this a while ago as i broke my breather tube off my clarke fuel cap so i bought a airline fitting sorry i cant remember the size but i just got the smallest that fits a breather tube
take the rubber gasket off, from the top drill out the hole working you way up to 12mm dont just go stright for a 12mm as its easier to keep the hole centered by working your way up, push the fitting in the hole so its stright then using a vice push the fitting in making sure its going in true and keep going till the bottom of the fitting reaches the bottom of the hole, remember to clean off any lose bits of plastic swarf and refit gasket cap, use a meduim size flat blade screw driver and gently push the edge back into pleace around the edge. its not air tight around the hole but its really close to it so fuel will have a hard time getting out around the fitting the hole is more then enough for venting |
#2
|
||||
|
||||
Man...I wish you would have posted this a month or so earlier....I replaced the cap.....nice fix!
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#3
|
|||
|
|||
ah sorry mate, its about a month ago i done it, i broke the cap on the first ride after i put the tank on i wasnt very happy on how easy it broke
|
#4
|
||||
|
||||
No problem.... $ 6.95 for a cap was not too bad!
Thanks
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#5
|
|||
|
|||
That's a good job on the vent spigot replacement. I had a problem with the cap actually cracking, so I bought the billet aluminum cap that Clarke offers. Nice and sturdy with only a slight weight penalty.
__________________
2011 EC250E |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
breather tube | bonkeye | Enduro Engine - 2 stroke | 5 | 03-13-2012 06:09 PM |
white gunk coming from crankcase breather tube | Crankin04 | Enduro Engine 4 stroke (including EFI & Exhaust) | 22 | 07-18-2010 09:58 AM |
and then this thing broke.... | dank | Enduro Intake/Carburetion - 2 stroke | 2 | 03-21-2010 05:18 PM |
Did I broke something in that picture? | GasTimppa | Pictures & Videos | 7 | 02-20-2010 03:46 AM |
Broke the new 08 in on Saturday | REVERUP | General Discussions & Announcements | 1 | 04-07-2008 11:05 PM |