Sachs fork bleeders

[Kiriakos cy]

Hi.i have a 2010 ec300 gasgas six days and i would appreciate if someone can tell me from were i could order fork bleeders.the frond forks are sachs 48mm. I am from cyprus and the dealer has no idea so ever.

[husley]

My 2010 sachs forks had bleeder holes to small for a speed bleeder. I purchased the Motion Pro bleeder kit and had my Tuner install the
. They require drilling and tapping the hole and they are permanent, they are also about 1/2 as tall as other bleeders

[Kiriakos cy]

Thanks. I found bleeders from americanbeta site.2012 4t beta models have the same forks as gas gas (sachs).my problem is that delivering them to cyprus will be too expencive for me ( app ?70 )

[swazi_matt]

I took the fork caps to sn engineering shop and got them to drill and tap the bleed holes to m5 (I think - just see what size bleeders are available)

[Kiriakos cy]

Thanks.probably will think about this solution

[Kiriakos cy]

In case i dont want to drill,does anyone knows if the strs fit the sachs 48mm??

[TNT Cycle]

Watch out I have a 2010 300 with Sachs fork and it has a different cap than the 2012 Beta I have seen. I sell them and have one in the shop now. Screw is not the same and Beta bleeders will not work on older fork cap.

[Kiriakos cy]

What bleeders do u use for ur gas gas?u have sachs 48mm?

[Gasgasogeros]

http://2tracing.it/ricambi-gas-gas/s...la-sachs-2011/

[TNT Cycle]

I used the stock screws but if I were to do it I would use the motion pro models with the tap kit.