|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
mysterious crank
has any one seen a crank from a 2001 xc200 with a primary gear held on by a snap ring? i pulled my crank out recently for a rebuild and was expecting a bolt to be there. according to the microfiche 200's have a bolt while the 250's and 300's have a nut.
|
#2
|
||||
|
||||
That sounds unusual. I recently rebuilt my 200, and found that even amongst those that have been selling and repairing gas gas for a long time, there's not so much knowledge about the 200 engine. I'd start with an email or call to the importer for your country. Out of interest, do you have a photo of the crank ?
__________________
'00 Montesa Cota 315R '13 Husaberg TE 300 |
#3
|
||||
|
||||
Sounds like a home brew fix to me. They should have bolts. Is there a threaded hole for the bolt? If done well it should be fine.
|
#4
|
|||
|
|||
crank pic
here is a photo. the hole in the end is very small and not threaded.
|
#5
|
||||
|
||||
I wonder if they substituted with a crank from a different brand at one point?
__________________
2018 EC 300 |
#6
|
|||
|
|||
I just came across a Gasgas crank on eBay that apparently is from a 2000 ec200 and it looks like mine.
|
#7
|
|||
|
|||
No worries, my 2000 200 had snap ring although my 1999 200 had bolt. I have owned eight gassers and found many small and some not so small unknown differences.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Crank bearing help please!!!!!!! | Porkyblader | Enduro Engine - 2 stroke | 2 | 09-09-2011 04:46 PM |
Crank it up! | Rick | Pictures & Videos | 2 | 04-09-2011 12:36 PM |
"Mysterious" valve | Krasi | Enduro Intake/Carburetion - 2 stroke | 13 | 11-14-2008 07:39 PM |
crank bearings | steve | Enduro Engine - 2 stroke | 0 | 02-06-2008 02:51 PM |