|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2003 300 feels cramped!
I have been messing with the setup on my 03 300 and it feels very small. Anybody else notice this? It makes standing on the bike very tireing. Ive fitted some taller bars and modified some YZ clamps to move the bars forward but its still feels short. Im thinking of upgrading to a newer bike does anybody know if the newer frames feel the same??
|
#2
|
||||
|
||||
Quote:
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc |
#3
|
||||
|
||||
The pre '12 bikes were always referred to as the 7/8ths bike.
Due to the smaller chassis. |
#4
|
|||
|
|||
Ok good to know. I think I?ll start shopping for a 2012+
Any year better than the others?? There seems to be a lot of 2013 for sale for good prices. |
#5
|
||||
|
||||
2012s were a flop. '14 on up were the best years.
|
#6
|
||||
|
||||
I'd stay away from the 12, but 13 should be ok. But as already mentioned, I would reccomend the 14 and up. There you will get the Reiger rear shock.
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc |
#7
|
||||
|
||||
That's correct I've measured my friend's Beta xtrainer side by side with my 2011 ec250 and they are almost identical in size.
|
#8
|
||||
|
||||
I am 6'4" and I ride a 2000 and I had the same problem I found the Fastway pegs in the lower position helped. I have my bars up one inch and forward one inch from the stock position. Straighter bars with little curve back helps too.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Clutch lever feels notchy only when engine is running | Zman | Enduro Engine - 2 stroke | 5 | 03-08-2015 09:51 PM |
Clutch Lever Feels Notchy | Zman | Enduro Engine - 2 stroke | 3 | 11-10-2014 06:14 PM |
2003 200 de | jimjim | General Discussions & Announcements | 3 | 03-19-2014 01:44 PM |
Oil on sm 125, 2003 | EmilO | Enduro Engine - 2 stroke | 0 | 04-09-2008 02:15 PM |