2018 XC 300 right side cover removal

[tree dodger]

Does the water pump impeller need to be taken off before the right engine side cover can be removed. If so, how do you keep the impeller from turning when you remove the screw? The impeller is plastic and i cant figure out a good way to hold it without damaging it.

[TGM_OFFROAD]

Originally Posted by tree dodger

Does the water pump impeller need to be taken off before the right engine side cover can be removed. If so, how do you keep the impeller from turning when you remove the screw? The impeller is plastic and i cant figure out a good way to hold it without damaging it.

Yes it needs to come off. Its been a few months but I seem to remember being able to hold the impeller in place with my hand. Also a small impact driver may be helpful in getting it off.

[Doc Brown]

No, no need to take the water pump off. It comes off in one piece with the inner cover. You also dont need to take the clutch cover off.

[Neil E.]

Doc Brown is correct. When you put the RH cover back on, do so carefully. The water pump drive gears need to mesh. You may need to turn the impeller a bit.

[Gasser Nate]

Sometimes you need to heat up the case around the front dowel hole. It usually corrodes due to the open bolt hole.