|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Balancer shaft - Timing
Been a while since i did my - now deceased GG.
Bloke at work has a 300 Quad and pulled it all apart. How do you time the CB shaft? There's a punch mark on the gear but i can't remember where you align it if at all |
#2
|
||||
|
||||
Here is a picture of how IT IS NOT supposed to be timed.
The two dots on the mating gears need to be aligned. Sorry the picture is a bit fuzzy. Dang auto focus. Hope this helps. Jeff |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PV timing? | Fred1956 | Enduro Engine - 2 stroke | 3 | 04-14-2011 11:40 AM |
Timing a 450? | iancp5 | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 05-28-2010 10:17 AM |
07 timing? | wence | Enduro Electrical & Wiring | 15 | 10-28-2009 03:42 AM |
Need HELP with timing | gasser | Enduro Engine - 2 stroke | 2 | 03-23-2009 02:17 AM |
For all who know Timing?? | nwcycle | General Discussions & Announcements | 0 | 03-21-2009 11:25 AM |