Plastics needed for OLD !!! 1998 EC250. What fits it?

[98ec250]

I'm looking to change all the plastics on my 1998 EC250 vintage bike, LOL !!!

I have heard that 1998 era Kawasaki KX250 stuff will fit.
I've seen some kits for about $120 on fleaBay, but I wanted to do a little homework before pulling the trigger.
I wouldn't mind using newer era parts if possible to spruce it up a bit while I'm at it, as long as it wouldn't require a ton of fabrication time.
I would greatly appreciate any input.

Thanks!
Jim

[Cruiser]

shrouds are GG specific, and 97-99 only, side numberplates and rear fender are 94-98 kx 250. front fender.. I forget what fits.. I think kawi, yamaha have the same bolt spacing.. the kdx200 wide front fender in black I have had before.. and I think I ran a yamaha one too.. check parts crossover on the gasgasrider.org main page.

[Bambam]

I also have a 98 and a 99 Gas Gas go to eurodirt.com he has some new blue plastics for a 98 on there.

[98ec250]

Thanks for the great info guys !!!

[desertgasser300]

You can use any brand of front fender that you like. I have 2005 yamaha in black on my 97. The
UFO aftermarket fender I ordered did not come pre drilled. I did have to cut a little off the back end to clear the pipe.