|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
06-15-2019, 08:53 AM
|
|||
|
|||
Power spread question.
Hi,after 3 years of ktm 300 2013 I return to GG. Is about ec 300 2010 six days.
Handling vs ktm? Years better!!!! But,the power is to abrupt where power valve opens. Carb specs: 42, NECW#3 172 main. All stock,spacer on reed cage. The power is there but is to smooth until pv start to open. Possible the 13-48 is long ? But if I install 50 on elrear will be to short on gear. Anyway seems to be shorter than ktm. There I have 13-52 and it feels higher. 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| power valve question | Getoviq95 | Enduro Engine - 2 stroke | 2 | 07-11-2016 02:40 PM |
| power valve question | kp_kp | Enduro Engine - 2 stroke | 10 | 03-20-2015 10:35 PM |
| gg250f loss of power question | forgiven | Enduro Engine 4 stroke (including EFI & Exhaust) | 22 | 12-04-2013 06:05 PM |
| Power valve bearing question | Rabbitist | Enduro Engine - 2 stroke | 6 | 11-11-2011 01:35 PM |
| Another Power Valve question | Link | Enduro Engine - 2 stroke | 4 | 01-04-2008 03:48 AM |
Linear Mode
