|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Wiseco forged piston in 2013 "A" cylinder
Hi All,
I searched through the old threads and didnt see anything about this but has anyone run a forged Wiseco piston in the 300 "A" cylinder. Mine has about .0023 clearance between piston and cylinder currently. They claim they only make one 72mm size. Since the 'A' on mine = 71.93 i'm a little concerned. Thanks! Oh and what is suggested ring end gap? Couldn't find it in my manual online. |
#2
|
||||
|
||||
Bob Piper@ North Tahoe Motorsports. Great service .Quality parts
__________________
'12 XC 200 TTX Sold '15 XC 250E Sale pending |
#3
|
||||
|
||||
Wossner has a piston for the 71.93mm (A) cylinder. Ryan Callies at Finishline Engines has good prices on Wossner in Wisconsin. http://www.finishlineengines.com/
|
#4
|
||||
|
||||
Thanks guys! I ended up with a Wossner. I've used them many times and found one available quickly. I've had them build 4 custom pistons for me a year ago. Just had a Wiseco that was close. I always like to stick with what I know works.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PLEASE HELP !! wiseco CR250 forged piston in newly nikasiled cylinder | savage sausage | Enduro Engine - 2 stroke | 33 | 03-01-2016 05:43 AM |
"B" piston in an "A" bore? | Kokanee | Enduro Engine - 2 stroke | 6 | 09-04-2006 07:10 PM |
Recommendation: add "Injury/Recover" and "Riding Techniques" sections | MattR | Suggestion Box | 2 | 07-18-2006 09:19 PM |