|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
400 fse cam/valve clearances
Hi
Ive just measured the valve clearances on my bike and they are bigger than what the manual says, my mate says that if the gaps are bigger then its ok and that it's when they are smaller that u need to do something about them is this true? bit of xtra info: the manual says inlet 0.15mm and exhaust 0.25mm clearance. my bike measures inlet 0.20mm and exhaust 0.30mm i'm just a bit concerned 'cos if the worst happens i wo'nt be able to afford a top end rebuild. Thanks for ne advice |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
to valve or not to valve.... that is the dilema. | dank | Enduro Suspension | 19 | 05-06-2010 07:41 PM |
Top End Clearances/Specs | SpeedyManiac | Enduro Engine - 2 stroke | 4 | 09-24-2009 09:53 PM |
fse 400 valve timing ??????? | mcludd | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 08-29-2009 11:54 AM |
pwr valve knock | dustbuster | Enduro Engine - 2 stroke | 10 | 08-06-2007 01:36 AM |
Valve Help | bxb | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 03-06-2007 05:31 AM |