|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Power Valve rebuild
Hi Gents,
My power valve rattles on Idle and I want to freshen It up a little....Any Ideas on what should be replaced? Such as bearings etc... Thanks |
#2
|
||||
|
||||
Disassemble, clean, and replace bearings. Bearings are very cheap, I replace them every top end job. Under the right side PV cover, make sure the actuator plate is in contact with the stop bolt with just a very slight(barely any) amount of preload with the engine off. If it floats over the stop it will rattle more at idle, but a small rattle is normal. This can be adjusted under the sidecover if neccessary.
|
#3
|
|||
|
|||
Thanks GMP, Ill replace the bearings and give it a good cleaning and see if it helps
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
power valve vent ? | walker1008 | Enduro Engine - 2 stroke | 6 | 01-14-2010 08:36 PM |
Power valve spacer | bitoman | Enduro Engine - 2 stroke | 7 | 06-15-2009 03:47 PM |
Power Valve Spacer | Dingo | Enduro Intake/Carburetion - 2 stroke | 16 | 01-22-2009 01:53 PM |
Power valve malfunction | Warwick Simpson | Enduro Engine - 2 stroke | 2 | 08-27-2008 07:10 PM |
Power valve | bens25au | Enduro Engine - 2 stroke | 2 | 02-09-2008 11:02 PM |