|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
clutch basket question
i have an 03 ec 300 , and while i was changing the clutch plates i noticed that i have a some back and forth freeplay between the basket and drive gear riveted to the back of the basket , i was just curious if this is normal for a gasgas. thanks Dave
|
#2
|
||||
|
||||
Quote:
http://www.gasgasrider.org/forum/showthread.php?t=3885 |
#3
|
|||
|
|||
i was going to order a new basket but after reading that link ill just order new dampers and rivets. thanks Man
|
#4
|
|||
|
|||
Give Jay Hall a call and he can fill you in on the problem. He probably has the parts if you can't get them at your dealer. Halls Cycle in Springfield Ill. I was skeptical when he said that this was the problem on my bike, but sure enough it worked.
__________________
2008 KTM 300xc Plated |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
clutch basket mod | stainlesscycle | Enduro Engine - 2 stroke | 5 | 02-09-2010 10:12 AM |
Clutch Basket | jriley43 | Enduro Engine - 2 stroke | 2 | 03-10-2009 02:12 PM |
125 clutch basket | GasGas | Enduro Engine - 2 stroke | 1 | 09-08-2008 10:46 PM |