|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
premix ratio for 300 two-stroke
I just picked up this quad and LOVE IT!! However, there was no owners manual. What is the best premix ratio??? I read on one of the sites about 80:1??
Is this correct?? I run 50:1 on my KTM
__________________
"Live to Ride, Ride to Live" 05' GasGas wild300 quad 05' Kawasaki Prairie 700 quad 05' Kawasaki KFX 400 quad 05' Kawasaki KX250f bike 03' KTM 200 exc bike |
#2
|
|||
|
|||
The actual oil mixture you use is a matter of personal preference.
The manufacturer lists 50:1 with a synthetic oil. But I prefer to run 36:1 with a good synthetic. More oil in the mix provides a greater amount of lubrication for the bottom end. The extra oil also provides greater ring seal and serves as a medium to transfer heat away from the piston. I look for a JASO-FC rating on the two stroke oil. This is a japanese spec - only a top quality synthetic two stroke oil can meet this spec. jeff |
#3
|
|||
|
|||
GasGas Trials bikes run 80:1 (mostly very low rpm, lots of idling, very mild tuning). Some oil manufacturers will tell you they can run 100:1, but I wouldn't do it in any motor I own. I run 80:1 in my trials bike though.
|
#4
|
|||
|
|||
thanks guys....
__________________
"Live to Ride, Ride to Live" 05' GasGas wild300 quad 05' Kawasaki Prairie 700 quad 05' Kawasaki KFX 400 quad 05' Kawasaki KX250f bike 03' KTM 200 exc bike |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FAQ: Premix Calculations | MattR | Enduro Intake/Carburetion - 2 stroke | 20 | 02-11-2019 01:30 PM |
premix | W8TSON | Enduro Engine - 2 stroke | 31 | 08-11-2009 09:52 AM |
gear ratio breakdown?? | Cruiser | General Discussions & Announcements | 3 | 04-06-2009 08:53 PM |
what ratio to premix at? | j@y | Enduro Engine - 2 stroke | 16 | 05-18-2007 09:53 AM |
Pre-Mix ratio | gasIdaho | Enduro Intake/Carburetion - 2 stroke | 8 | 03-21-2007 11:17 AM |