|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Swingarm shims...
Just took my swingarm off as I'm doing an engine rebuild. Does anyone else have shims on the outermost part of their swingarm? The parts manual shows none, but I had shims, I can't imagine they are original as the ID is smaller than the center roller. Can only imagine they were put there afterwards, anyway, I've ordered some 22x32x1 shims that will clear the centre roller but help retain the o-rings, unless its common to shim the whole assembly width?
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
#2
|
||||
|
||||
I have never seen them but i suppose they could be used to align the sprockets.
|
#3
|
|||
|
|||
I bought some stainless shims slightly larger than the top hat/inner race to take uo the gap between the frame and the o-ring.
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ohlins shock shims | kiwigasgas | Enduro Suspension | 10 | 08-25-2016 08:13 PM |
Shims to spare... | SGM | Enduro Suspension | 1 | 11-30-2012 10:12 AM |
Buying Shims - Where? | Idahocharley | Enduro Suspension | 3 | 12-19-2011 08:46 AM |
Where order shims | borsiin | Enduro Suspension | 5 | 12-10-2008 04:45 AM |
Marzocchi 45 stock shims | vavido | Enduro Suspension | 2 | 05-28-2008 04:31 PM |