|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Flywheel and stator help
Hey ppls, i know this is probably really easy but....
I don't know how to get to the flywheel and stator. I haven't done it before and i am not sure how to access them. I did a search for any threads about this but I couldn't find anything. Any help with pictures would be great!! Thanks |
#2
|
||||
|
||||
plastic left side cover on end of crank. 4 bolts. you're gonna need an impact to get the flywheel nut off, and a flywheel puller - can't remember what size.
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#3
|
||||
|
||||
Pretty sure its a 27mm x 1.0mm thread for the fly wheel puller. You can also use a bit of starter cable down the spark plug hole, a special plug engine stop, or a holder on the flywheel to get the nut undone.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2k3 stator with cdi from 2k2 | whodat | Enduro Electrical & Wiring | 3 | 07-21-2013 10:34 AM |
"race stator and flywheel" | hallyfromspen | Enduro Electrical & Wiring | 1 | 02-28-2012 06:42 AM |