|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
11-21-2022, 02:51 PM
|
|||
|
|||
Aluminum particles all over the place 2018 300
During slow ride gearbox locked in 1st, then freed and worked flawlessly again.
I do hear some noise now with clutch disengaged and occasional, could even be, extreme chain like rattle sound. By hand, everything is rock solid, no play, rotates freely, no broken case parts, at least on the outside. Since currently not really up to tearing engine again, I'd flush it and clean all rotating parts, clutch etc.. Whats would be better, diesel or gasoline? 3rd pic shows really amateurish oil cutout from rekluse. Only alu, no steel, checked by magnet. Any experience with that?
__________________
EC 300 2008 EC 300 2018 GP tenere 700 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best place to buy parts? | DLap13 | Enduro Engine - 2 stroke | 6 | 09-01-2017 06:00 PM |
| GasGas in second Place | hadfield4wd | General Discussions & Announcements | 3 | 05-03-2017 07:29 AM |
| Central PA place like HMT | hadfield4wd | NorthEast United States | 1 | 04-04-2017 07:12 PM |
| Best place for OEM hardware? | Koko | General Discussions & Announcements | 25 | 09-02-2012 11:02 AM |
| this may not be the correct place to ask, but... | compmoto | SouthEast United States | 6 | 10-30-2010 02:10 PM |
Threaded Mode