|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Baseline jetting help 08 ec200
My buddy just bought a 08 ec200. I couldn't even get it started without running the air screw all the way out. The needle is N "can't make it out" HW. The 50 pilot ain't helping. The slide is an 8. I'm a fairly decent 2 smoker tuner. But have never seen this needle. And it's in the 4 position.
The bike also has ltr PV cover, thanks inadvance Last edited by Pinittowinit; 04-22-2014 at 12:05 AM. |
#2
|
||||
|
||||
Guessing it has the older AS1 Carb. Start over with the basics.
Set the float level Use a known needle that will put you in the ballpark Start rich and adjust back Remember that its using a #8 slide which is quite lean for a 200. You may consider running a thicker diameter and pilot than other specs. |
#3
|
|||
|
|||
(reply based on 200cc)
that is a lean slide. most seem to prefer the 6.5. mine came with a #6 and I switched to a #7, but haven't gotten it dialed in yet.
__________________
2011 GasGas ec300R 2011 GasGas ec200 Six Days |
#4
|
|||
|
|||
|
#5
|
||||
|
||||
I ran an 07 200 for a few years.
I was running the NBHW needle you probably have, on the 3rd clip pos, a 175 main and that fat 50 pilot. At 40:1 with Elf 2XT tech. Note, I'm in NZ and not very cold, not very high up. |
#6
|
|||
|
|||
I'm thinking I'm gonna stick a Jd blue in there. Clip 3, 40 pilot 172 main. See how that works out.
I haven't checked the jets yet but my buddy told me the pilot is a 50. It's so rich on idle now it will barely start. I have a box of needles collected over the years. I suppose I could just drop the pilot to a 45 and see what happens. |
#7
|
||||
|
||||
I'm running a CCL in an 07 & around a 48 or 45 depending.(in NZ)
Read some of the head mod threads, it really does help clear up bottom end running. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FAQ; Suspension baseline settings | LTRace | Enduro Suspension | 39 | 04-06-2019 06:51 AM |
sachs shock baseline? | stainlesscycle | Enduro Suspension | 9 | 10-06-2011 07:10 AM |
2005 baseline settings | stay_upright | Enduro Suspension | 0 | 01-26-2009 08:37 AM |
baseline ohlins setting | fullthrottle | Enduro Suspension | 5 | 04-26-2008 08:15 AM |
EC300 Baseline settings | Magellan | Enduro Suspension | 7 | 08-26-2006 06:30 AM |