|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Contact Sudco in Cali.
__________________
'12 XC 200 TTX Sold '15 XC 250E Sale pending |
#12
|
||||
|
||||
Its a generic choke plunger.. Search PWK choke. Ktm/Yamaha/Honda/... etc all use them.. shame on you for still having that cable attached!
|
#13
|
||||
|
||||
2nd that! Go to Yamaha and get a choke assy. for a 07 yz250.
|
#14
|
|||
|
|||
Thanks for the replies, none of my local shops have the plungers for even the Jap bikes, so I got one coming from Halls. X fingers that is my problem.
|
#15
|
|||
|
|||
So I had 2 issues. I fixed my choke and then my throttle cable came loose on the carb and was sitting 1/2 cocked in the opening. Fixed both issues and fixed the free play. Turned air screw 1.5 turns out. Now the bike breaks up really bad after 1/4 throttle to redline. Power is good down low but signs off early and runs harsh. Would this be too rich? I had dropped a clip position in the winter as it was running lean from mid to top. Now it just breaks up and never smooths out.
|
#16
|
||||
|
||||
Sounds rich on the needle. Burble burble. Make sure the new choke is closing properly too.
|
#17
|
|||
|
|||
Plug is white. It IS terrible lean.
__________________
07` EC300SM. 09` KTM 250EXC. 70`CB350 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
plug read | pigpen966 | Enduro Engine - 2 stroke | 3 | 02-17-2015 10:57 PM |
Read this plug | IDAHOSPUD | Enduro Intake/Carburetion - 2 stroke | 7 | 07-03-2014 09:03 PM |
Picture of the week 10/21 | gasgasman | Pictures & Videos | 3 | 10-22-2012 03:37 PM |
2K2 Picture | cladoo | Enduro Electrical & Wiring | 10 | 04-16-2008 10:01 PM |
Nice Picture! | Mark Berg - CPD | General Discussions & Announcements | 3 | 04-02-2008 08:21 PM |